Eurosec pr5208 rev10 user manual1/1/2023 ![]() ![]() Your installation company will have programmed the reset modes for your system so that it complies with your insurance company and legislation requirements. : Resetting After An Alarm Resetting After an Alarm After an alarm the system needs to be reset.If an alarm occurs when the system is set, the cause of the alarm will be displayed for 10 seconds after you unset the system. Proceed to the keypad and enter a valid User Code. Enter the premises via an authorised Entry Point. : Unsetting The System Unsetting the System. ![]() Enter a valid User Code followed by 2 or 3. Part 2 is a second set of zones that may be omitted and Part 3 will combine Part 1 and Part 2. Two other Part Sets may be available for your system. : Part Setting The System (using Part 2 Or 3) Part Setting the System (using Part 2 or 3).The display will show, for example:- If the fault clears within 20 seconds then the exit tone will begin, if not, the fault tone will continue until a valid User code is entered. tone will sound if any non exit routes are Zone 3 open. At the start of the setting procedure, a fault Exit Now !. Exit the premises via an authorised exit route. * If enabled by the installation engineer. After checking the premises are secure: Enter a valid User Code followed by. : Full Setting The System Full Setting the System.The bottom line of the display will then be blanked off. Set or Unset Status will only be displayed for ten seconds when the system is Set or Unset. : Display Status Blanking Display Status Blanking Depending on Control Panel installed, it may be a requirement that the Status (Set or Unset display) of the security system is not displayed.Throughout this manual, reference will be made to the Master User Code, the factory set default is 5678. Several user programmable options are available that will be covered later in this manual. Your installation company will have programmed your system to protect your premises to the highest possible standards. : Introduction Introduction Welcome to the eurosec control panel.: Table Of Contents Contents Introduction.Eurosec Pr5208 Rev 1.Related Manuals for Eurosec CP8L Summary of Contents for Eurosec CP8L.Eurosec Pr5208 Rev 1.0 User Manual User.Our books collection hosts in multiple countries, allowing you to get the most less latency time to download any of our books like this one. Eurosec alarm manual pr5208 is available in our book collection an online access to it is set as public so you can download it instantly. Programming User Codes Up to nine user codes may be programmed on predetermined. User Manual for Eurosec PR5208 Domestic Intruder Alarm. Programmable User Options Several user programmable options are available via user codes 1, 2 or 3. Introduction Welcome to the eurosec control panel. Programming User Codes Up to nine user codes may be programmed on predetermined levels. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |